• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Anybody here running a Summa cutter off of Flexi using a Mimaki printer?

gabagoo

New Member
Anybody here running a Summa cutter off of Flexi using a Mimaki printer?

I'm at my wits end... I need to find someone with this setup to figure out why my cutter has so many issues finding registration marks....anybody?
 

FrankW

New Member
Would be VERY HELPFUL to know the model of your cutter.

There are two main generations of OPOS, and the older one could have problems with todays inkjet printers because of possibly low density of the print. It is possible to calibrate the sensor (is named media calibration).
 

gabagoo

New Member
D-140 2008 Sometimes it has no problems but then I can spend upwards of an hour fighting with it, using every trick in the book to get it to see that first square. It will seriously end my life one day I fear!!! lol
 
Top