can´t run summa d60 with latest winplot

[1234]

hi,
i use summa d60 without usb, so it runs with

summad60 (parallel plug) -------------------> pc (serial plug), or

summad60 (parallel plug) --------------------> pc (usb plug)

for some reasons i´ve to reinstall windows xp, and now i´ve problem to
run my plotter propperly.

i know there is no special driver for it. usually, first you install winplot, than
choose connection, parallel or usb, and finally choose LTP ,or other ports.

if i choose the blue , and like to cut via plug-in of corel x3, it says :
"fail to get extents from cutter CUTCMD_FAILNODEVICE".
if i continue clicking ok, then it finaly works.

on the other hand, when i connect the red, pc finds immediately the cable.
it recognizes it as "IEEE 1394 Bus host controllers", but doesn´t work, neither from com1/usb nor ltp port.

i´m totally lost. any idea please??
thanks alot
george

 

[KR3signguy]

http://summausa.com/support_downloads.php?type=firmware&sess_id=358c0c828a174052e6d2efc19058af0f
Download the latest firmware:
Firmware Revision 019 for Summa S Class

 

[1234]

thanks for advice.
i´m just curious, why it worked before without any problem??
i may forgot something unimportant, and now i pay the price
by the way, the main problem is, that i´ve to install plotter like
a new printer, and it can´t find it anywhere.
best wishes

 

[GTArt]

hi,
i use summa d60 without usb, so it runs with

summad60 (parallel plug) -------------------> pc (serial plug), or

summad60 (parallel plug) --------------------> pc (usb plug)

for some reasons i´ve to reinstall windows xp, and now i´ve problem to
run my plotter propperly.

i know there is no special driver for it. usually, first you install winplot, than
choose connection, parallel or usb, and finally choose LTP ,or other ports.

if i choose the blue , and like to cut via plug-in of corel x3, it says :
"fail to get extents from cutter CUTCMD_FAILNODEVICE".
if i continue clicking ok, then it finaly works.

on the other hand, when i connect the red, pc finds immediately the cable.
it recognizes it as "IEEE 1394 Bus host controllers", but doesn´t work, neither from com1/usb nor ltp port.

i´m totally lost. any idea please??
thanks alot
george

Hi I'm having the same issue on a Summa D750 and I'm just inches away of selling it and buying something
more easy to setup....

Did you manage to make it work and how?

Many thanks

 

[Asuma01]

This post is almost 10 years old. You are better off just writing up a new post. Since it seems like you are having problems I reccomend contacting summa support. Its what I did when I first set up my summa plotter and they helped me get it going.

 

[GTArt]

This post is almost 10 years old. You are better off just writing up a new post. Since it seems like you are having problems I reccomend contacting summa support. Its what I did when I first set up my summa plotter and they helped me get it going.

 

[GTArt]

Hi,
I know it's a bit old but like you've seen it the person I was asking might see it too and I'm trying to ask anyone has experienced similar issues as I have contacted Summa Support and they're quite slow to respond at the moment..

Thanks