CNC Routing Software

[Oleeo]

Hello everyone, well my old Dell win xp computer running Enroute 3 has finally given out
really don't want to pay $125 per month for a subscription - have run this set up for 20 years with no problems
Is there anything else out there comparable without a subscription ?

 

[tbullo]

I'm sure that I'm in a small minority, but i use Cadlink ProfileLab. I use signlab and it works just like that and was easy for me to pick up. It's not cheap, but i think they will give you a free trial.

 

[Dale D]

Hello everyone, well my old Dell win xp computer running Enroute 3 has finally given out
really don't want to pay $125 per month for a subscription - have run this set up for 20 years with no problems
Is there anything else out there comparable without a subscription ?

Vectric
Aspire is 1 of the most popular and is purchased out right. They have a more basic Cut2D for basic 2D for about $150 and a mid range VCarve 2.5D

 

[cornholio]

Get an old XP box and move the harddrive over. Except the harddrive died...

 

[netsol]

Hello everyone, well my old Dell win xp computer running Enroute 3 has finally given out
really don't want to pay $125 per month for a subscription - have run this set up for 20 years with no problems
Is there anything else out there comparable without a subscription ?

get Someone to power it up one more time.
( mount the hard drive in another similar “junker”
run a “p to v” converter and virtualize the install so it runs on the new computer
or just buy a similar older dell for$50.. on eBay and swap the hard drive