Composer not cutting vinyl completely

[ken692]

we have a problem with lots of trouble cutting I have to weed each letter
yet the backing shows cut marks its like the vinyl is resealing itself I tryed everything new knife back strips The enVision™ 375 and Odyssey 48 yet both have this same problem I even tryed two computers 1 amd and 1 intel help help
Ken

 

[Replicator]

My guess would be cutting FORCE as I dont have this plotter !

 

[skyhigh]

what brand of vinyl? My guess, its not orical.

 

[ken692]

FORCE is set to 25 but even at 28 no go
defualt is 21.88
not sure on the vinyl but I will find out
i'm new but dom been doing it since 1990
and he never had this problem

Ken

 

[Jillbeans]

When mine does that it means that the sprockets need the boogers scraped off, or that the bar that the cutter head rides on needs oiled, or that there is a piece of a sticker stuck on the bar that the back end of the cutter head rides on.
...or you need more weight.
Love....Jill

 

[ken692]

everything is clean I have 2 envision one new and one a few years old both are acting up its gerber 220 vinyl
gerber wants to see the cuts under a microscope
wow
this is a pain in the vinyl

Ken

 

[animenick65]

Sometimes this happens to me on my graphtec. It usually happens when I use a new blade. It cuts the backing paper (usually too much so it leaves some on the vinyl when you pull the release liner) but yet the vinyl doesn't weed well. Try as I might, not matter what settings I use it does this. I usually have to deal and run a couple rolls through it until it dulls a little then its fine. Its the weirdest thing!

 

[ken692]

we changed the computer and still have this weed problem if the vinyl sits for a few days it shrinks and weeds fine

 

[Shovelhead]

Maybe....

there are open nodes on the file??

 

[ChicagoGraphics]

Is there any vinyl stuck to the blade or maybe you need a new blade holder

 

[ken692]

Is there any vinyl stuck to the blade or maybe you need a new blade holder

no nothing is open just a zip car file
I did change the blade holder new blade and cut strip and its still same problem, if I weed from left to right it seems to lift better
right to left into the open holes and its a problem
almost seems like parts of the words cut deeper than other
oh ya we orderd a new print head $900 and I installed that did the calibration with no change if the vinyl sits for a few days it shrinks and weeds awsome but thanks for all the great ideas I have tryed them all
Ken Boston:signs101:

 

[Disciple]

Have you tried to click the double cut box. Keep your same settings and put the double cut on. I had the same problem you are having and when i use double cut i have no problems weeding after that.

Another thing you may want to try is changing your cut settings inside the cutter itself. I found that does help too.