Daigle Laminator problem

[CENTERVILLE SIGNS]

When I step on the foot pedal my laminator turns very slowly or not at all

 

[Solventinkjet]

Usually that means the jam sensor is being tripped. Make sure nothing is sticking up too high or your fingers are getting too close the roller!

 

[sardocs]

I have a Daige that had that problem. Turned out to be a broken cotter pin on the drive gear. It had sheared so it was able to slip on the axle. Once we got the sides off it was an easy fix.

 

[CENTERVILLE SIGNS]

I have a Daige that had that problem. Turned out to be a broken cotter pin on the drive gear. It had sheared so it was able to slip on the axle. Once we got the sides off it was an easy fix.

 

[netsol]

does the motor need a drop of oil, or wd40?
any hum or noise?

 

[CENTERVILLE SIGNS]

I have a Daige that had that problem. Turned out to be a broken cotter pin on the drive gear. It had sheared so it was able to slip on the axle. Once we got the sides off it was an easy fix.

I have a Daige that had that problem. Turned out to be a broken cotter pin on the drive gear. It had sheared so it was able to slip on the axle. Once we got the sides off it was an easy fix.

I don't

I have a Daige that had that problem. Turned out to be a broken cotter pin on the drive gear. It had sheared so it was able to slip on the axle. Once we got the sides off it was an easy fix.

I don't see a cotter pin