I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I called flexi sign and they said I can't run a graphtec fc7000 with 7.5 and I would to upgrade to at least flexi 8.1. Anybody have any suggestions for a good rip and contour cut software other than flexisign?
When I had 7.5 I ran my fc7000 using one of the lower drivers. I don't have it in front of me but I think I used FC 4000 or 5000 or something.
It ran fine.
If you go to the flexi website you will find a free upgrade for 7.6 ver 2 and it has support for the graftec fc7000 included. I had the same problem for the same plotter.
Thanks guys!!
I found and downloaded flexi 7.6. I was using a usb connection and the software was sending the information but the cutter wasn't receiving it. I have to go get a parallel port to serial port and see if that fixes it.
If you now have Flexi 7.6, the USB connection should not be a problem... The driver within Flexi 7.6 for the FC7000 should support the USB port on the cutter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.