So I have a SP-540v and it has been a (slow) work horse for many years but for some reason here lately it seems like I am having to take apart, remove encoder strip and clean it constantly. Usually takes 2 cleans to get it going right and it will work good and then roughly a week later, same thing. I have flipped the old one over and after that didnt seem to help I just bought a new one. Stuck that one in and I have the same problem. Could there be another issue going on here? Doesnt seem to have any bad over spray, clean shop, not over worked, out of ideas.
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Encoder Strip Issues
- Thread starter K2
- Start date
Solventinkjet
DIY Printer Fixing Guide
You probably need a new sensor. They go bad too. What kind of print issues are you having?
Roland Product Support
New Member
Hey K2,
VanderJ is right, the problem is likely the encoder sensor. You should call your Roland dealer to discuss this with them and possibly order a replacement sensor.
Take care,
Roland Technical Support
Roland DGA Corp.
rn
VanderJ is right, the problem is likely the encoder sensor. You should call your Roland dealer to discuss this with them and possibly order a replacement sensor.
Take care,
Roland Technical Support
Roland DGA Corp.
rn