Gandi 3150 x2 Jeti Encoder Error?

[cwb143]

Today my Jeti hasnt been able to print. We had a electrical storm over the weekend out some of our power was out. However the printer started up and the print carriage will make the first run down the table and just die almost at the end of the strip and coast the rest of the way into the metal stop and just quit. It did this three times in a row. and the error message on the screen says. X axis did not move properly or encoder error. I have wiped down the strips and the Lights are always green on the encoder sensors. Any Ideas

Thanks
CWB

 

[National Sign Co. - Print]

Today my Jeti hasnt been able to print. We had a electrical storm over the weekend out some of our power was out. However the printer started up and the print carriage will make the first run down the table and just die almost at the end of the strip and coast the rest of the way into the metal stop and just quit. It did this three times in a row. and the error message on the screen says. X axis did not move properly or encoder error. I have wiped down the strips and the Lights are always green on the encoder sensors. Any Ideas

Thanks
CWB

Try slowing the carriage speed down to about 1300 and see if you get the same error. May need to reflash motion board. It may be freaking out....

 

[cwb143]

Ok I'll give it a try. Now if it dosnt work where can flash the motion board?

 

[National Sign Co. - Print]

If you never flashed a board. Do not attempt with out a tech on the line giving you every step along the way. It is not something you should mess with solo the first time. You could kill the boards with one click of the mouse.

 

[cwb143]

Ok thanks for you help!
1300 did not work it was rough on stops when the carriage has to come back. so I'll call the Tech.

 

[cwb143]

Turns out it was a bus fuse in the back above the ink tanks. LOL