Gerber Edge beeps

[Hielorojo]

Hello, I have problems with my Gerber I, I turn on it and it start to beep, I turn off and turn on again and the beeps again....any advice?
Thank you.

 

[gabagoo]

Mine now does this more and more frequently. I have an LE and I open the lid and gently rotate the printer on its side. There are 3 screws underneath on each side and you open these panels ( more likely the one on the left side) and I ground myself and gently make sure everything is connected properly. It works and the machine is back up and running again. I will warn you that ever since I did it the first time, my shock absorbers have gone dead and I need to use a bungee cord to keep the lid open...so beware that afterwards, do not open the lid and walk away as you could do serious harm to the print head. Good luck

 

[Hielorojo]

Thank you for your answer Mate! The mine work well, after of open/close the lid many times( 5 o 6), Is possible that any negative (-, earth) connection is not correct .
Thank you again and sorry for my English.

 

[stevesign]

As the last Post suggests, take off the screws on the side, and release the side panel, and inside the panel is a black reset switch.

Hold this in, and power on the machine.

If it works, replace the cover, My gerber edge I has the problem often.

 

[gabagoo]

As the last Post suggests, take off the screws on the side, and release the side panel, and inside the panel is a black reset switch.

Hold this in, and power on the machine.

If it works, replace the cover, My gerber edge I has the problem often.

i did not know about the reset switch... Is this on an LE?