Need Help Gerber Edge LE Quits Print Halfway and Beeps Like Crazy

[Will308decals]

Hi everyone,
I am printing on my Gerber Edge LE and the following happens:

I am printing black on top of silver, the silver prints perfectly but when the black is loaded in the printer will go a foot or so and then rapidly beeps at me. I have tried different foils and still have the same issue.

A picture of what is happening is attached. The print will just stop and Edge beep like crazy. I cannot reset or restart the print.

Any input would help!

(Silver now did not print this last run)

 

[Will308decals]

Update. Printer wont print anything. It will turn on fine with no noise but as soon as I send a job and click online and get to the actual printing stage, it beeps like crazy. Screen sits on "warming up" while beeping

 

[gabagoo]

I know when my starts the beeping, I have to turn off the power, carefully turn it on it's side and then remove the 2 panels to gain access to the computer boards. Usually a loose connector causes the beeping, which one is the question, so I just push them all in and hope I got the right one. Put everything back, turn it on and in most cases the beeping has ceased and I can start printing again.

 

[Will308decals]

I know when my starts the beeping, I have to turn off the power, carefully turn it on it's side and then remove the 2 panels to gain access to the computer boards. Usually a loose connector causes the beeping, which one is the question, so I just push them all in and hope I got the right one. Put everything back, turn it on and in most cases the beeping has ceased and I can start printing again.

I have seen your posts in the past. Does yours beep as soon as you turn it on? Or does it beep when you try printing? Also is it a rapid beep that you aren’t able to stop? I cannot reset the printer or anything I have to turn it off for the beeping to quit

 

[netsol]

I have seen your posts in the past. Does yours beep as soon as you turn it on? Or does it beep when you try printing? Also is it a rapid beep that you aren’t able to stop? I cannot reset the printer or anything I have to turn it off for the beeping to quit

the is a document with all the beep coded.

 

[gabagoo]

I have seen your posts in the past. Does yours beep as soon as you turn it on? Or does it beep when you try printing? Also is it a rapid beep that you aren’t able to stop? I cannot reset the printer or anything I have to turn it off for the beeping to quit

Usually it starts when the printer is turned on, but to tell you the truth I don't really use it much anymore and can't honestly remember....and yes it will continue until you turn it off and try and remedy it.