Gerber Edge Overprint

[Heartbeat Designs]

I am printing a decal on clear vinyl. It is going to be used inside on the windshield of vehicles. So I have reversed the print order when I flip the image. It's a fire department logo with red, black, silver & white. I have tried to get white to overprint on top of all the colors so they stay more opaque and have not had any success in doing so. I'm not sure what I am doing wrong can someone help. Thanks

 

[Fred Weiss]

Create your setup as right readng with all colors except the white set to overprint. In GSP
Plot set the job to reverse reading and also reverse the print order. It should print fine following that approach.

 

[Heartbeat Designs]

I set it up that way and I can't get it to look right once I set things to overprint. I am really at a loss what I am doing wrong I have never had this trouble before. But I am out of practice using my edge obviously. Mr. Weiss would you be open to me emailing you this file so you could look at it and tell me what I am doing wrong?

 

[Fred Weiss]

I set it up that way and I can't get it to look right once I set things to overprint. I am really at a loss what I am doing wrong I have never had this trouble before. But I am out of practice using my edge obviously. Mr. Weiss would you be open to me emailing you this file so you could look at it and tell me what I am doing wrong?

Send it over.

 

[Heartbeat Designs]

Send it over.

I sent the file to allcompu@allcompu.com

 

[Fred Weiss]

Got it. What version of Omega do you run?

 

[Heartbeat Designs]

Version 2.51