Got a whole county wanting street signs...

[Banners Signs Etc.]

Umm...Where do I buy them in that quantity and/or how do I make them?

.08 aluminum and reflective... Should I contact the local federal prison?

 

[Gino]

They only make license plates.

 

[rjssigns]

Not sure if those fall under MUTCD regs or not. Best check before quoting.

At any rate you can order the reflective blanks from a place like Grimco then cut the green overlay film on your plotter and apply.

My choice would be to have a specialty wholesaler knock them out.

 

[Banners Signs Etc.]

Anyone know a wholesaler of these?

 

[SignProPlus-Chip]

Anyone know a wholesaler of these?

We may be able to help. Send me sizes and specs and I can get an estimate to you.

 

[BIG EASY DOES IT]

Umm...Where do I buy them in that quantity and/or how do I make them?

.08 aluminum and reflective... Should I contact the local federal prison?

Contact Grimco. They can fabricate them all or get you the blanks. Or sheeted blanks. Depends on how much you wan to do in house. Their finished signs have a very good resale price.

 

[TXFB.INS]

Contact Grimco. They can fabricate them all or get you the blanks. Or sheeted blanks. Depends on how much you wan to do in house. Their finished signs have a very good resale price.

yup, just finished up an order for handicap parking signs doing exactly this

 

[StarSign]

I just PM'd you

 

[ams]

Check with your substrate supplier, mine makes extruded blanks with green reflective ready to go, all I have to do is cut white reflective letters and put on it. Cost $20 each double sided

 

[decalman]

Well I'll be darned. I didn't know street signs had vinyl. I didn't know how they were made.
They don't seem to wear out.

 

[BIG EASY DOES IT]

Well I'll be darned. I didn't know street signs had vinyl. I didn't know how they were made.
They don't seem to wear out.

Because these signs were made properly with proper matched materials meant for permanent long term usage.