• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Graphtec FC7000-130 / Corel X3

Imminent Death

New Member
Hey guys,

We recently obtained Corel X3 and I'm trying to get our Graphtec FC7000-130 setup to where we can die-cut with it.

In a nutshell: t'aint workin'.

I've downloaded new drivers from Graphtec (located at http://www.graphtecusa.com/products.php?visit=img&cat_id=1&series_id=33&view=D), burned them to a CD, and ran the installation. Towards the end I was asked where I wanted to install for Illustrator, but not Corel. Corel X3 has a Cut/Plot option, but when I send the die-cut to the Graphtec, I get "Error 1 Instruction Not Recognized". On a side note, I can't cut through Illustrator either.

Any ideas? I can't find beans for good documentation on the web.
 

Bill Modzel

New Member
You need to switch the Language on the Graphtec from HP-Gl to GP-GL or visa versa. Hit Menu>next>next>interface>Command to switch it.
 
Top