-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Graphtech fc 8000-75 question
- Thread starter CYPSIGNS
- Start date
bob
It's better to have two hands than one glove.
Make sure that Background Settings->Condition Priority is set to 'Manual'. This will make the plotter ignore any set up commands received. This being the desired state of affairs.
nopalito24
New Member
Yes, there 2 ways. (on the plotter)
1, from your ready screen press 1 select user, then 2 user priority and select Keypad. try another cut job.
2, if the above does not do it then press MENU, TOOLS, Condition priority, select Manual. This should do it.
1, from your ready screen press 1 select user, then 2 user priority and select Keypad. try another cut job.
2, if the above does not do it then press MENU, TOOLS, Condition priority, select Manual. This should do it.
Universal Industrial Sales
New Member
I actually had the same problem, what we had to do is change the setting of the condition number it likes to change too, so far it has changed from an 8 (which we would normally use) to a 1, then two weeks later it changed to a three. So our #1,3, and 8 condition numbers are all the same force, speed, etc... but we use our machine maybe once a month. We also have a list of problems with our cutter. But we are figuring most of them out.
Signs Excetra
New Member
Does anyone know how to set my Graphtec FC8000 back to the factory settings?
