-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
heater temps for cjv30
- Thread starter ironchef
- Start date
Neil
New Member
That's about right.
I think mine is 35 40 45.
Here's a tip if you want to turn off the heaters at will.
Switch to cut mode and press the heater/cutter button twice (then enter).
I found that because I drive this machine through Signlab, the heaters would fire up and stay on even in cut mode when I just want to cut something.
Being able to turn them off is handy. Pity you can't do the same override in print mode.
I think mine is 35 40 45.
Here's a tip if you want to turn off the heaters at will.
Switch to cut mode and press the heater/cutter button twice (then enter).
I found that because I drive this machine through Signlab, the heaters would fire up and stay on even in cut mode when I just want to cut something.
Being able to turn them off is handy. Pity you can't do the same override in print mode.