• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Help! Gerber Sabre 408 error during ORIENTATION

A

Amos

New Member
I have a Gerber Sabre 408 and its been a very reliable cnc for many years now but yesterday it is not able to finish orientation. It turns on and as soon as I push A to orient it throws a X axis error while orienting or it says error while orientation.
Thank you for any help
 
A

Amos

New Member
StarSign said:
Is the screw dirty?
Click to expand...
Hello StarSign, thanks for reaching out. It is an older screw, but I don't see much of anything on it. If I turn all power off and push the gantry back and over so it has to travel a bit while trying to orient, it moves fine until it hits the far-left side then it trips and throws the error code.
 
You must log in or register to reply here.
Top