How do I level the head?

[Ken1f]

Yesterday I replaced the black dampers on my 1204 and when I was trying to get all the air from the lines I noticed that the caping station was not drawing ink. I removed it and cleaned all lines but when I was about to replace it I noticed that the head is a lot higher in the rear (red arrow) than the front (blue arrow) did I do this when replacing the two black dampers? I'm not sure about the proper way to make it level again. Any help would be appreciated.

Thank you.

 

[Stealth Ryder]

you somehow moved the head from it's correct position while replacing the damper... remove it all and start over, the head will "snap" into place when it is installed correctly...

 

[Ken1f]

Thanks, you were right on the money. I had loosened a couple screws just in front of the dampers then decided that was not the way to get to the dampers. When I retightened them I didn't realize that the back of that pc. had moved causing the pressure that changed the head. I pulled all the dampers, replaced the pc and now the head is where it belongs.

Ken

 

[oldgoatroper]

Coming from a sailing background, my first thought was, "head up into the wind..."

 

[Ken1f]

Coming from a sailing background, my first thought was, "head up into the wind..."

:ROFLMAO: I have to be more careful on how I post.
Should have been.
"How do I level the head on my mutoh valuejet 1204? I screwed up and need help."