HP 360 latex

[TCC]

I have a broken belt on my 360 Latex. Anyone have a service tech in Midwest they have used? I'm in Iowa but trying to get this repaired. Company, I bought from is no longer in business. Any ideas would be greatly appreciated.

 

[balstestrat]

If you are techy and your times not worth doing anything else, it's not too bad of a diy job.

 

[TCC]

any special settings? it broke behind the carriage, pulled apart. I have seen belts online.

 

[balstestrat]

You just have to get it out. Both ends covers off, encoder out, right end piece off, carriage just out and new belt in same way as old.
Getting it back together correctly..

 

[Stefanie]

I have a broken belt on my 360 Latex. Anyone have a service tech in Midwest they have used? I'm in Iowa but trying to get this repaired. Company, I bought from is no longer in business. Any ideas would be greatly appreciated.

We did it ourselves a few years back there are youtube videos step by step. We had the machine serviced some milestone service that needed to happen the tech mentioned the belt which is not part of that service so we purchased the replacement and then one night when it broke we replaced it. It takes sometime but not difficult just have to dismantle the printer so it takes time and patience and a good set of hex head screwdrivers or bits.

 

[greysquirrel]

hp part surfer has service manual pages for repair