• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Issue with Graphtec 8600 Plotter

R

Renato Pinto

Graphics Manager
Not sure if you can see it in the picture, but one of our plotters is shifting a tiny bit after it gets to a certain point in the vinyl.

The E in Release and L in All have a weird extra corner that shouldnt be there.

Any ideas? We have three of these plotters and they use illustrator templates to do their work. However, only one of the plotters is having this issue.

Thanks!
 

Attachments

  • graphtec plotter issue.jpg
    graphtec plotter issue.jpg
    120.4 KB · Views: 256
Solventinkjet

Solventinkjet

DIY Printer Fixing Guide
Does this issue happen in multiple areas or just 1 per job? It's a weird one for sure. I would suspect a motor/drive issue. Perhaps the speed reduction belt that connects the motor to the drive belt has missing or damaged teeth. I would take a good look at the motor area and see if anything seems off.
 
R

Renato Pinto

Graphics Manager
VanderJ said:
Does this issue happen in multiple areas or just 1 per job? It's a weird one for sure. I would suspect a motor/drive issue. Perhaps the speed reduction belt that connects the motor to the drive belt has missing or damaged teeth. I would take a good look at the motor area and see if anything seems off.
Click to expand...
Apparently its every 40", so that must be a belt issue, correct?
 
You must log in or register to reply here.
Top