JV33, wiper dry and clean.

[petesign]

JV33, wiper must not be wiping?

Noticed last week, the wiper looked really clean... today I go to clean the machine again, and it's still clean, and bone dry. What would cause the machine to stop using the wiper?

 

[Fit2Win]

If you put your JV33 into service mode and get into the #adjust menu you can do an adjustment for the wiper. There's a chance that its not aligned properly with your printhead.

 

[ChicagoGraphics]

I'm not sure how the wiper system works on the JV33 but on a JV3 theres a small sensor that need to be cleaned every once in a while or otherwise the wiper doesn't come out to wipe the heads.

 

[DustinD]

Have you replaced a head recently? If so the head might not be all the way in. Also if you lower the carriage height is it still missing the wiper?

Put a piece of vinyl in the door switches and take a look while it's cleaning. Lower your carriage first.

 

[Masseria]

Have you replaced a head recently? If so the head might not be all the way in. Also if you lower the carriage height is it still missing the wiper?

Put a piece of vinyl in the door switches and take a look while it's cleaning. Lower your carriage first.

who the hell uses the door?, lol.. firts thing i made asap is to unscree the metals from the acrlyc and put in the sensors.. no more problem.

Try adjusting captop and wiper in service mode.. there is a guide to do this. got the manual too if you need it.