Latex 365 Labels & Marks question

[Roto]

We have a new Latex 365.

I print Labels at the end of each job using the Label & Marks Tab in Production Manager.

The problem is that when we use the Cut Contour function it ignores the Print Job Label and prints with no identification.

I believe it can be turned on somehow, does anybody know where this setting maybe?

TIA
__

Roto

 

[HulkSmash]

ah, if you had caldera i could help you with that.. flexi is just.. yuck!

 

[bannertime]

Just as a refresher: It's possibly turned off when switched to cut contour. Are you using Presets? If so, then a preset may have been saved with the mark width set low and the labels turned off.

 

[Roto]

Just as a refresher: It's possibly turned off when switched to cut contour. Are you using Presets? If so, then a preset may have been saved with the mark width set low and the labels turned off.

Thanks, but no that's not it, in the RIP when I load a cutcontour job it shows print labels as being active.
I believe it is a setting somewhere just a matter of finding it.