Looking for the best 8" panel saw blade...

[signgirl]

Looking for the best 8" blade that will cut through Lusterboard ( double sided material, plywood with metal faces) smoothly. No matter what I use I always have to remove the spurs from the cut edges. Any recommendations appreciated. Not finding anything in my area.

 

[Gino]

After cutting, go back with a file and DE-bur it.

 

[rjssigns]

Get ya one of these: 8 Piece Mango II Set M Hand Deburring Tool 33873548 - MSC

We call 'em Widow Makers.

 

[Rydaddy]

Ditto. (deburring tool). Also, Asking the same saw blade to cut aluminum and plywood perfectly is a stretch.

 

[signgirl]

Yes, I've used the debuting tool for years. Just wondered if there was something out there I haven't heard of

 

[S'N'S]

I use a minimum 100TPI blade, still has some burr but not as bad as the lower teeth count blades. I see some of the ferrous metal cutting blades are 128TPI. Google non burring 8" saw blade.

 

[henryz]

I've use the Diablo blade and cut up to .125 aluminum with very little burr left and like everyone suggested take a deburring knife and comes right off.