manual crop mark detection

[spudcity]

has anyone tried using the manual crop mark detection? I have tried it a couple of times because of forgetting to change the rip to cut from print after laminating and it never seems to work.

Any suggestions?

 

[anotherdog]

is this when you have printed the print and cut crop marks or when you forgot to print them?
I have printed laminated then cut many times with no problem.

 

[vectorterrorist]

I was just wondering this after the place I work for bought a new graphtec and I saw a little pen to make manual crop marks...very interested in learning how this works

 

[spudcity]

this would be after laminating. I put the crop marks on properly, but like an idiot I forgot to change the rip from print to cut. It started printing over the top of the old marks and then the printer gave me a crop mark errror when I tried to cut it.

I ended up solving the problem by just cutting the additional ink from around the original crop marks, but I was still curious if anyone had tried the manual crop mark detection on the SP300V with any success?