Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Need some Signcut X2 software help...

Discussion in 'General Software' started by Red-Eye, Apr 25, 2007.

  1. Red-Eye

    Red-Eye Member

    202
    0
    16
    Sep 1, 2006
    Maryland
    I am stuck until I get help and I havne't heard back from Signcut yet.

    so if you are familiar with it, i would appreciate alittle help.

    I changed the dimensions from mm to inches.

    In open my file and adjust the size to 12"x12"

    But it cuts it about 26" wide.

    What am I doing wrong? this is very frusterating.
     
    Tags:
  2. ChicagoGraphics

    ChicagoGraphics Major Contributor

    4,770
    53
    48
    Feb 27, 2007
    World
    What cuts 26" wide?
     
  3. Red-Eye

    Red-Eye Member

    202
    0
    16
    Sep 1, 2006
    Maryland
    my file that i have set at 12x12"
     
  4. WulfGrafix

    WulfGrafix Member

    33
    0
    0
    Sep 22, 2006
    I've had Signcut do this to me too, here's what I did.

    At the top of the window, there are four buttons... Image, Measuring Frame, Tiles, Cutter.

    If I set the image size with the numbers below the Image button, it cuts all kinds of strange.

    Click on the Measuring Tool on the left (third one down) and draw a measuring frame around whatever you are cutting. Go to the numbers below the Measuring Frame button up top, and change it there (click and drag to highlight, type in whatever size you want, and press enter). If you want to keep things in proportion, make sure there is a little green dot in the upper circle.

    Good luck, I hope it works.

    Dan
     
Loading...

Share This Page

 


Loading...