no valid epos reference was found error

[nina]

hello pls i need help after that i prepared my file and make cut contour i puted the vinyl in my plotter ultima sc 1400 D i have cut server 2.0 ( onyx 7 )
i did i did 4" front and back
2" left and right and i still have this error pls help me what i must do

sorry for my english

 

[westpointsigns]

What kind of vinyl are you trying to cut?
Is it White Vinyl?
How many points does it try and sense before you get the error message?

 

[CentralSigns]

Welcome to Signs 101 from the Rockies !!!!

 

[nina]

i use avery whit vinyl glosse, the point i think it did 2 point , so it move normaly and it stop in the point of start sorry for my english

 

[nina]

i can show you my fils after printing this is the link pls :

http://cjoint.com/?0dFpkAuhhtO

and i still have this error in my cutter ultima SC1400 D ( no valid epos reference was found ) pls help me what i must do
http://cjoint.com/?0dFpkAuhhtO

 

[randya]

Have you done the EPOS alignment out of the users manual?

 

[nina]

yes BC code single can you see my file?

 

[Graphics2u]

Have you used the EPOS before now or is this the first time? I don't use Cut Server with mine and I don't use the Bar Codes like your print has either. I have had that same problem, but it's usually just that I have a pinch roller to close to the box or the material is too short on the back end.

 

[westpointsigns]

Why are you printing the page off the cover of your Mutoh Instruction Manual?

 

[nina]

yes i did , witch material is short you mean??

 

[westpointsigns]

Usually when the material is too short I get the error saying "END OF ROLL TOO SHORT".

When that happens I tape some scrap material that is the same color as the material that is printed to the back of it and make it long enough.

I also leave at least 5"- 6" on the back side of the print to avoid that error.

 

[Graphics2u]

yes i did , witch material is short you mean??

Sometimes if the vinyl is too short at the end of the print the cutter doesn't have enough room to perform it's alignment.

Do the triangles next to the bar codes point to the back of the print?

 

[Graphics2u]

Can you do a print without the bar code? Just use the box only? That's all i use, but I'm using FlexiSign also.

 

[nina]

i cant do it with no bar code because i use onyx 7 so i must choise ultima mutoh when i riping ,
look this is my file pls open this link

http://cjoint.com/?0dFpkAuhhtO

 

[Graphics2u]

I see that you must use the bar code with Cut Server. I don't have experience with that program, i'm sorry.

 

[nina]

yes i use cut server onyx 7

 

[randya]

Does this happen on all print/cuts or just this one?

 

[nina]

yes in all printcut

 

[heyskull]

This is a weird answer but:-

Is your machine in a bright place?
Our sc1400d will not read the refference lines if it is in direct sunshine or bright lights.


SC

 

[nina]

no it is not , Although light bulbs? can make problem??,