Question Onyx Thrive 12 swatches from color sample far off - Latex 560

[tollerdad]

I sample a color in Onyx Thrive and the auto patches are so far off the sampled color. Any idea with this happens? I would think they would start close then change in lightness and hue.

 

[White Haus]

Are the source color device values shown in your screenshot the same as if you use the eyedropper with the color replacement tool?

I know I sometimes get thrown off with "device values" and "output values"... not sure if that's what's happening here.

 

[tollerdad]

Yes same values.

 

[White Haus]

Yes same values.

That is odd. I'm fairly sure when we print swatches (just did earlier today) the start/sample point was much closer than that.

You could always uncheck auto-patches and enter your starting values in the top left corner and leave the rest to default...but still doesn't seem necessary.

Will check when I'm downstairs.

 

[tollerdad]

That is odd. I'm fairly sure when we print swatches (just did earlier today) the start/sample point was much closer than that.

You could always uncheck auto-patches and enter your starting values in the top left corner and leave the rest to default...but still doesn't seem necessary.

Will check when I'm downstairs.

Great Ill give that a shot.

 

[tollerdad]

I see where it allows me to enter percentages of the color but not a different CMYK breakdown.