MrSalumi
New Member
Hey everyone. I am having a hell of a time getting my Opos to work properly. Here are the details.. I am printing on a Roland Soljet2, Using Wasatch to RIP and create registration marks, and cutting on a Summa S140d.
So my issue is that I load my print in to the cutter and press "actions -> Media Alignment", It prompts me to set the knife over the first mark. Which I do.. Then it searches and finds the first mark. It then starts looking for a mark about an inch up from the first mark.. Almost like it's looking for the OPOSxy line. Once it doesn't find the next mark it prompts me to set the knife over the unfound mark, which I do. It doesnt find it again and then it errors out.
Is there anyone who uses Wasatch to Cut with a S Series Summa? Any ideas if I am missing something? PS my alignment mode is set to OPOSx and the OPOS parameters are at the minimum of 32mm and I have tried 2 and 4 number of marks..
ARGH!!!! Thanks for the help!
So my issue is that I load my print in to the cutter and press "actions -> Media Alignment", It prompts me to set the knife over the first mark. Which I do.. Then it searches and finds the first mark. It then starts looking for a mark about an inch up from the first mark.. Almost like it's looking for the OPOSxy line. Once it doesn't find the next mark it prompts me to set the knife over the unfound mark, which I do. It doesnt find it again and then it errors out.
Is there anyone who uses Wasatch to Cut with a S Series Summa? Any ideas if I am missing something? PS my alignment mode is set to OPOSx and the OPOS parameters are at the minimum of 32mm and I have tried 2 and 4 number of marks..
ARGH!!!! Thanks for the help!