Plotting mystery with Graphtec plotter

[signsnowdaytona]

Lately my Graphtec FC 7000-75 will plot everything fine out to about 78'' and nothing more. I cut out of Flexi Sign and this has never happened before. Whatever is at that 78'' mark gets cut off, for example a letter O would look like a C but without the path closed on the top and bottom. The file is at 100%, I define the width and the length is set at 1968'', more than adequate. Can't figure this one out, any help would be appreciated!

 

[Techman]

check the length of the section in the control panel.

 

[P Wagner]

check the length of the section in the control panel.

+1
Go into the Menu System on the Graphtec (via the control panel), and look for the parameter labeled 'Page Length', and change it to a large value (>1000 inches), and save.

 

[signsnowdaytona]

I forgot to say thank you...Thank You! It was the setting in the plotters menu. I did a software update and I'm guessing it went to a default setting because I never go into those settings.