Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

pnc 960 cutter

Discussion in 'Roland' started by Cadmn, Sep 30, 2005.

  1. Cadmn

    Cadmn Very Active Member

    2,859
    0
    0
    Aug 19, 2005
    I tried the other day to cut a side panel for sons car 72" & my pnc960 wouldnt cut that far what program is recommended for bridge from corel It has to be cheap I dont normally need that long of a cut
     
    Tags:
  2. OldPaint

    OldPaint Major Contributor

    what program are you cuttin from? and did you try to reset your page size in you in the driver setup?
     
  3. Cadmn

    Cadmn Very Active Member

    2,859
    0
    0
    Aug 19, 2005
    OP using corel 12 & yes set my size to 72"L 15" W
    was told I needed bridge program but if others are doing it without then why cant I ???
     
  4. OldPaint

    OldPaint Major Contributor

    960 isa 24" plotter right? youre not setting the page right. it will default to 62.99. you have to manually reset this value to 80", or 96". and corels page will do up to 150 feet x 150 feet.
     
  5. Cadmn

    Cadmn Very Active Member

    2,859
    0
    0
    Aug 19, 2005
    ok I'll give it a try yes it is 24"thanks for info OP
     
Loading...

Share This Page

 


Loading...