Designs by Stacy
New Member
Hello,
I am doing a print job in signlab that has fills. I rearranged everything to get it printed onto two sheets.
When I put it over to my print and cut manager I got an error. So I felt the file was to large. So I selected only 1/2 of my file. Again that is to large. I finally selected one line at a time and have been printing this one pickup lettering job for two days. One line at a time.
When I did the fills I selected one letter at a time and filled each one seperately. Because I felt it looked the best that way.
Is this whats going on?? Should I have NOT selected each letter seperately when I filled them??
Can some one help me out so I don't run into this problem again with fills.
Any help would be appreciated.
Thanks,
Stacy
I am doing a print job in signlab that has fills. I rearranged everything to get it printed onto two sheets.
When I put it over to my print and cut manager I got an error. So I felt the file was to large. So I selected only 1/2 of my file. Again that is to large. I finally selected one line at a time and have been printing this one pickup lettering job for two days. One line at a time.
When I did the fills I selected one letter at a time and filled each one seperately. Because I felt it looked the best that way.
Is this whats going on?? Should I have NOT selected each letter seperately when I filled them??
Can some one help me out so I don't run into this problem again with fills.
Any help would be appreciated.
Thanks,
Stacy
