• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Printing Problem

cyoky

New Member
Hello, I run JV3-130SPII.

Just ran a print in fine mode and it is printing a shadow through out the entire print. I ran a sample in std mode with same result. I tried in fast mode and print came out good.

I cleaned with no improvement.

Any suggestions?

Thanks,

Oscar
 

MobileImpact

New Member
sounds like your calibrations in the standard mode are off. Not a big deal, but should have a tech come in to calibrate it.

Kevin
 

cyoky

New Member
Thanks for the insight.
It did come out sellable in fast mode. I completed print and sold signs, but still concerned about the problem.

I will call tech.

Thanks again.
 
Top