Software Help RasterLink 6 overcut

[alevit53]

Good Morning All,
Anybody know a way to adjust the over/under cut in Rasterlink 6 running on a Mimaki CJV 150-160?
Can't seem to find any settings.
thanks for your help.
Art

 

[Solventinkjet]

It's in the "Composition" tab. I can't remember off the top of my head but you basically can reverse the composition and it will change the order of the print and cut.

 

[alevit53]

I guess I wasn't clear in my question.....We are getting little "tabs" on corners making it difficult to weed. I think we need to overcut them slightly and I cannot find that setting.
thanks

 

[Solventinkjet]

I guess I wasn't clear in my question.....We are getting little "tabs" on corners making it difficult to weed. I think we need to overcut them slightly and I cannot find that setting.
thanks

I believe that is a setting on the printer itself. Check in the cut menu for Overcut. You set the length you want it to overcut and then the machine will take care of it.

 

[Solventinkjet]

I had a chance to check out mine. It's in the Cutting Menu>Setup Sub Menu>Overcut.