Rasterlink

[ECVSoares]

Hi, I have a mimaki CJV-30, and I used Rasterlink... The prints started to come out bigger than the original files, for example: a job with 3000mm comes out with 3030mm...
Does anyone know what to do to fix it?

 

[DL Signs]

Is it in the feed direction? Run the feed compensation in the setup menu, it'll print a test pattern, change the values till it's correct. Instructions are in the user manual under Media Correction.

 

[ECVSoares]

Is it in the feed direction? Run the feed compensation in the setup menu, it'll print a test pattern, change the values till it's correct. Instructions are in the user manual under Media Correction.

It is in length not in width, 1 piece with 2000mm feed comes out with 2020mm.

 

[DL Signs]

Length is what the feed compensation adjusts. It only takes a few minutes to run the test print and adjust.

 

[ECVSoares]

Length is what the feed compensation adjusts. It only takes a few minutes to run the test print and adjust.

Yes, I understand, I haven't adjusted it for some time, the 2 lines cannot be superimposed, I'll adjust it and see if it solves the problem, if not I'll reinstall the rasterlink. TKS