• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Roland Sheet Cut

bmep

New Member
Has anyone experienced hitting the sheet cut button after printing has finished and nothing happens. Hopefully I've just missed a setting somewhere on my sp540v.
 

signheremd

New Member
We have the XR640 and you hold the Sheet Cut buttom for 2 seconds and it beeps and then proceeds to go across the vinyl and cut it on the way back
 

netsol

Premium Subscriber
I imagine I would press setup again and do sheet cut once it is initialized

i will look if I have a service manual
 

bmep

New Member
I had a power surge that took out main board. I replaced the board and everything works good except sheet cut. Possibly the cut carrige board got hit also ?
 

Jim Hancock

Old School Technician
Check your front and rear media sensors. First, look inside both the sensor holes and make sure you can see both sensor eyes on each one. Next, blast them with some compressed air. If that doesn't work, clean them with a foam swab, just damp with alcohol. If it's still not working, go into service mode and check the F & R sensor responses by covering and uncovering the hole.
 

Attachments

  • SP-540 Sensor check.pdf
    238.2 KB · Views: 2
  • SERVICE MODE.jpg
    SERVICE MODE.jpg
    81.4 KB · Views: 2
Top