Hi everyone
I've been trying to cut a printed graphic all afternoon and I'm getting an error.
It finds the 1st crop mark fine, when is starts moving along to read the 2nd crop mark, it stops every 6 odd inches and moves the media goes back slightly, when it finally gets to the position of the 2nd crop mark, it's unable to read it as there is nothing there as it's too far back.
What is causing this?
I have tried cleaning the sensor and there doesn't appear to be anything on the print to stop it. I just can't figure it out. I cut the previous panels fine.
I've been trying to cut a printed graphic all afternoon and I'm getting an error.
It finds the 1st crop mark fine, when is starts moving along to read the 2nd crop mark, it stops every 6 odd inches and moves the media goes back slightly, when it finally gets to the position of the 2nd crop mark, it's unable to read it as there is nothing there as it's too far back.
What is causing this?
I have tried cleaning the sensor and there doesn't appear to be anything on the print to stop it. I just can't figure it out. I cut the previous panels fine.