Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

sp300v powers up w/o hitting sub power

Discussion in 'Roland' started by pengem, Nov 4, 2019.

  1. pengem

    pengem New Member

    Jul 23, 2011
    Morgantown, PA
    I could use some help please. I just replaced the scan motor. I plugged it back in, turned on the main power and the front panel comes on (without hitting the sub power) says cleaning...then service call 0002. Any suggestions?
  2. Solventinkjet

    Solventinkjet DIY Printer Fixing Guide

    Aug 2, 2011
    Denver, CO
    Make sure the cable that connects the main board and servo board is plugged in properly. If that is good, then the servo board or main board could be damaged electronically. My guess would be servo board as it handles the motors.
    • Like Like x 1

Share This Page