tooserious
Premium Subscriber
Hello I was wondering if anyone had tried to clear deflections on a Mimaki JV3 print head with a syringe and hose or damper and hose etc?????
-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Success Rate of syringe and JV3 Print head
- Thread starter tooserious
- Start date
Jack Knight1979
New Member
I do this all the time. the only time it won't work is if the face of the head is scratched. No amount of fluid will fix that.
You can also try to suck up through the bottom of the head as a last resort. There is a small screen in the head that can clog over time.
You can also try to suck up through the bottom of the head as a last resort. There is a small screen in the head that can clog over time.
tooserious
Premium Subscriber
Do I just leave the head in to do it I lost the whole head and then got most of it back ...I have soaked it forever??? Do you take a damper and do it or just the hose
mimakitech24
New Member
make sure its capped, and pull gently on the syringe, you can collapse the head if done incorrectly or you are too rough on it...