What is your experience with the HP latex printers

[guillermo]

I love the ink, we have a 365 and so far, it has been great, we use Onyx, flexi is installed, but it is complicated for me to use, I stick with Onyx.

 

[ozpall]

At my last job we had a Latex 260 and it was a decent printer the got traded for a 360 which the 360 got better colors and overcoat cartridge, then we got a 365 which is basically the same 360 with minor changes, then we got a 800 series and had trouble with it, it jammed to much and rubbed the media to much, I tried not to use it much; 2 years later we had expired ink on it but still prints, I realized that the drying area was an inch lower on the 800 compared to the 365, I made a jig to where I could print raising the drying module one inch and after that I ran it a lot more, I'm not sure if anyone else had this issue since the people that sold us the 800 could not fix, it is nice to have 3 litter ink on the 800, we did'nt have white ink on it, also the 800 you can turn the overcoat off but not on the 360's

would love to see the Jig, i have the same issue with the 700w jamming and scratching the material specially with perf, banner and gf222 which its "thick" the best thing so far is to crank the vacuum all the way to 100% and crank the inter-pass delay to like 350-400.

 

[Stacey K]

I love mine! I have the 315

 

[BigfishDM]

They are great machines and lots of support available.

 

[Bonzai901]

would love to see the Jig, i have the same issue with the 700w jamming and scratching the material specially with perf, banner and gf222 which its "thick" the best thing so far is to crank the vacuum all the way to 100% and crank the inter-pass delay to like 350-400.

I no longer work at that place but I can try to get you some pictures sometime next week; all it is is a 1'' think block to set on the right side under the curing module to rest on, on the left side you'll need a 1" thick rectangle to the size of the air duct and on the same left side a metallic tab to trigger the sensor (witch I stick with double side tape), the printer will show a message saying is not a 100% contact HP but as long it let you print is good,

 

[ozpall]

I no longer work at that place but I can try to get you some pictures sometime next week; all it is is a 1'' think block to set on the right side under the curing module to rest on, on the left side you'll need a 1" thick rectangle to the size of the air duct and on the same left side a metallic tab to trigger the sensor (witch I stick with double side tape), the printer will show a message saying is not a 100% contact HP but as long it let you print is good,

ok cool, if you happen to get a pic that would be great!
thank you.

 

[Bonzai901]

would love to see the Jig, i have the same issue with the 700w jamming and scratching the material specially with perf, banner and gf222 which its "thick" the best thing so far is to crank the vacuum all the way to 100% and crank the inter-pass delay to like 350-400.

I got some pictures here