Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Writting windows driver for plotter

Discussion in 'General Software' started by DanSSK, Aug 9, 2006.

  1. DanSSK

    DanSSK New Member

    Jul 7, 2006
    Not sure if this is the right place, but does anyone know a good starter place to write a windows driver for a plotter. I would say basing it on usbprint.sys would be best starting (assuming its connected via usb).

    The goal is to write a driver so cutters without factory windows drivers can cut from Corel adn other programs that need windows driver.

    Any help appreciated

Share This Page