• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

XC540 Cutting Problems

vicerhans

New Member
Hi I have a Xc540 printer has a cutting problem..
I have tried all settings but no luck.. i think problem is hardware problem..

After cutting complete (of course not correct cut).. cutting carriage seperated.. No stick to Magnet..
Please check the image.. here
www.emrevekaan.com/xc540.jpg
 

Joe House

Sign Equipment Technician
Your picture shows it connected. When it's cutting, it's not supposed to be connected to the print carriage. If your just getting a message that the carriages are separated, then you probably need to clean the encoder strip.
Check this out.

Good luck

Joe
 

vicerhans

New Member
Actually .. its seperating when its cutting yes. But when cutting is finish suppose to stick to magnet .. its not doing it.
I cleaned encoder but still same.. there is a hardware problem which i cant find it. :(
 
Top