I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Yes I have done a dishway already then turned off the machine overnight to let it sit in the cleaning fluid.
Hmm ok will give it a few more go's, I have however flushed cleaning fluid directly through the head too which didnt resolve it (that was the method I used to get the magenta and black...
Hi Guys
I have been running this JV3 for some years now and tackled many issues with dampers/pumps and everything surrounding them but this one has me stumped.
If you look at the attached image of my test draw I have just successfully pulled the Magenta and Black back from being completely...
Thanks guys, all sorted now! :D
Basically I got round the back and pulled thru the ink as suggested and heard a nasty air leak as i pulled on the syringe from the capping station, seems the magenta black head wasnt fitting well on the capping station, luckily i managed to swap with the...
Update!
Ok so I have tried flushing cleaning fluid thru the head to a degree of success, it fired back up and I now have half of my test on black and magenta! horrah! but then after a strong clean it went back down hill again!
What gives? could there still be a small air leak somewhere in the...
Thanks for the ideas so far guys, im going to try the above suggestion as a starter, when you say injecting the cleaning solution thru the heads, did you do this using the same tube to pull the ink into the dampers but just took the hard peice of plastic tubing off the end of the of the rubber...
Hi Guys
Ok moving on from this topic ( http://www.signs101.com/forums/showthread.php?t=64363 ) where we established the high likely hood of me needing to swap out a couple of dampers, i bought in 3 genuine mimaki ones and replaced KMC all went pretty smoothly and the cyan came back perfect but...
its on all medias and profiles, i will see if its on bi or uni, it just seems strange as nothing has changed so why would i need to change my print style to sort it out?
Thx for all the input so far guys, theyre genuine inks and the dampers are within 2 years old.
Ink starvation sounds like a possible? but how do i adjust sort that out?
I know what your saying about the cyan Vinylman but im not sure why that would have any effect on a straight black or cyan?
More pics...
Seems to be mainly with the black and magenta it is in the cyan very slightly but no where near as bad and mainly probably due to the head needing an extra head wash.
but it doesnt matter which media or profile i do magenta and black on im getting the same problem..
Any ideas???
The banding im not so worried about its the patchy printing thats my problem, its not the media as it does it on anything i put in it and also has worked no problem only 2 weeks previous.
The test draw is pretty good, no different to when i was last printing the very same graphic so im a bit...
Mainly with Blacks and reds i seem to be getting a patern forming badly in solids using these colours or variations off.
Tried cleaning everything, different profiles etc, same result, its a job i ran only 2 weeks previous on the same profile and media with no problem whatsoever.
My...
Hi Guys
Hopefully you can help me out?
Im using genuine Mimaki inks, the screen on the JV3 was telling me that i still had 1 quantity of ink left in the black cartridge when it apears it didnt and had run out, the machine doesnt get heavy use so its been a few days in this state and it wasnt...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.