Recent content by backwoodsgirl

Room temp had been 65, now I've got it about 72 to see if that makes any difference. So far I'm feeling sweaty. All Roland inks and parts. I use various media, concept glossy calendared, Roland pcv2, 3m ij1080, and some others. Always with appropriate profiles. I think you're correct in it being...

Thanks for the input, So when I am in Versaworks under Printer Controls, for Heater Controls should I select Use Custom Settings or Use Default Media Settings? Both read (40C and 45C)

It's a vector image, no issue with the file. No part of the print is good, its equally spotty throughout. So, this morning I put a humidifier in the office, waited a couple hours and printed the same file. And the print is MUCH BETTER. Maybe not perfect, but passable! Yesterday the humidity was...

Hoping someone can shed some light on this issue. I've been noticing prints coming out spongy-looking, not terrible quality but enough that I can notice a difference and I know my print quality (from exact same, un-edited files) was better a year ago. There's got to be a cause. - My test print...

Would help to know what material it is?

Waiting on an acrylic letter order from them, hope it's the updated pattern!

You are not TOO Far off on the pre-remodel look.

I'm dying here :D I may just run with it. But Hillsdale is more than just a bit backwoodsy....

Humidity in the shop can cause this even if just for a few hours. Funny thing is, if its too dry you'll also start drying out that adhesive wherever its cut. If you must use a repositionable vinyl, don't cut it until right before the install.

Funny, last week I finally moved into my donkey-barn-converted-sign-shop. And I've been struggling to name it. Pretty sure I'm just going to make a humble little sign that says "sign shop" and move on :D

Thank you but As I said, that is a different product. I have already found what I needed.

No, those hold signs flat to a post.

Would be nice to have one! I only do a handful a year and a cordless impact works ok.

Do you have a link? I did a search there first and didn’t come up with them.

municipalsigns.com $1.50.... they're in FL