Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
copythat
Last Activity:
May 10, 2018
Joined:
Apr 22, 2008
Messages:
760
Trophy Points:
18
Positive ratings received:
1

Post Ratings

Received: Given:
Like 1 3
Disagree 1 0
Agree 0 0
OMG / Wow! 0 0
Informative 0 0
I Appreciate You 0 0

Following 2

Followers 2

Gender:
Male
Home Page:
Location:
3159 Bruckner Blvd., Bronx, NY 10461
Occupation:
Owner

Share This Page

Profile Views

Total Profile Views: 4

copythat

Active Member, Male, from 3159 Bruckner Blvd., Bronx, NY 10461

Sign Up! Sep 29, 2017

copythat was last seen:
May 10, 2018
    1. copythat
    2. randya
      randya
      I would try cleaning it first.
      Usually these just get gummed up and dont move properly.
      Sometimes the sensor gets dirty or knocked out of place.
      You should be able to check the sensor operation in service mode.
      As well as exercise the wiper. (I think, anyway)


      Depending on the model and age, I might recommend replacing the maintenance station.

      On most ValueJets maintenance station replacement is fairly easy.
      Not even sure in the wiper is available separately.
      A quick note to Stealth Ryder would probably be more fruitful.

      Sorry, but I havent done any of these in years now.

      Good luck!
    3. copythat
      copythat
      Your the man thanks. I hope it works.
    4. randya
      randya
      Tommy,

      Most likely your capping station/head is not sealing that well.
      Make sure they are clean, you should clean them 1-2 times a week.

      The printer counts ink droplets and pump cycles to estimate how much ink is left in the carts. If the cap doesnt seal, it wont pump ink, but still count it.

      You should contact your dealer and get new cards for your carts.
      They will be at 100%, but it will allow you to empty out the carts you have.

      If you have any problems contact Customer Care at Mutoh, 1-800-99Mutoh.
      Give them your serial # of your printer and they can send out cards as well.

      Good luck!
      randya
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Home Page:
    http://www.mastergraphicsnyc.com
    Location:
    3159 Bruckner Blvd., Bronx, NY 10461
    Occupation:
    Owner
    Location:
    NY
    Country:
    United States
    Experience Level:
    More than 5 years
    Work Description:
    Print On Demand & Signage
    Plotters & Printers:
    Mutoh
    Signmaking & Graphics Software:
    Illustrator & Photoshop
    Sign Up!

 


Loading...