Recent content by Corwin Steeves

I love the print quality of this machine! I did have a few questions/concerns though... 1) Finger prints. Is this an issue? 2) Heat. I was concerned with printing on heat sensitive materials. (ie 20pt styrene, foamboards, etc) 3) Double sided. We do quite a bit of double sided printing and...

If you'd like to do this yourself then I would do this: Buy more 1/2" foamcore. Glue the two half inch panels together with the top face running vertically and the bottom face running horizontally. This will make the 7' x 7' a single strong one inch thick piece. Run one inch VHB around the...

There were a lot of runners on this thread and only one doer. :) Nice job man, looks killer. Here's one I did that made everyone nervous too. It's a historical landmark, so I had to make sure that the vinyl would not damage the surface of the stone which added a little drama. o_O

I see quite a bit of time has passed since you made your decision. How has it been??

6mil is too thick and 15 mil is waaaaay too thick. You don't need to use a cast IMHO. A basic 3-4mil calander PSV with a 3-4 mil lam would be just fine. All cheap cheap. I would think that a 15mil lam would be fairly expensive??

Hi all! I'm looking for a braille insertion tool for my Kongsberg cutting table. They recently came out with one, but they only fit their new machines. (surpise, surprise..) Does anyone know of an attachment that is universal to all or most CNC machines? Thanks!

The only way to get a better yield then this would be to run 8up.

I couldn't agree more with Eric. #respecttherainmakers

Awesome! Thank you gentlemen!

At first I was thinking of this.... But this would probably be even better.... 61” x 100’ 154,9 cm x 30,5 m 1 Roll KPPS61 Kodak Satin

Can anyone help a brother out? I've searched high and low and I can't identify this damn font!

Wow, thanks Merritt for posting that quote. I can't tell you how helpful that is. We're looking at replacing our Oce 6170 and I thinking that the Durst 250, the SpyderX and the Agfa are all good options.

Definitely, replace that filter. It's easy and cheap to do. But it could be the meniscus vacuum. That would have to be done by Oce. Does it do this on all materials or just one in particular?

Print it on a clear adhesive backed vinyl using the backlit mode, laminate and apply to the translucent acrylic. Easy peasy. :)

Thanks guys, advice taken, four tiles it is. I'll post a pic of the finished job!