Recent content by Do-Over

Doing just that! Just thought with so many "standard" type designs out there all these years... just thought someone was smart enough to put them all together in one place and sell them so the wheel doesn't have to be recreated. After all it's not "fine" art. and All I did was ask a simple...

...and...You are ?

Hmmm think I've done pretty well for a few years in the sign business and finally turning my hobby of engraving into a successful business as well. Seems my theory is correct. Hard work equals success.

Perhaps I would be a more active "stand-up" forum member (like I am on the glass and stone engraving forums) if it were not for those individuals who think they are God's gift to signs with the primary agenda of putting others down. If you want to sit in awe of how helpful I can be - visit one...

I looked at your profile as it is listed below and was wondering who you are to judge if I should be here or not. You look at my profile and ASSumed I was trying to avoid paying a sign shop? You have never seen my work, have no idea what I do, and have no right to judge wheather I should be here...

I'd like to apologize for the rants and thank everyone who tried to help but something needed to be said to those who think they know it all. Thanks to those who answered my question. and... if anyone has any questions on stone, granite, Marble, Boulder, or Rock engraving...I'd be more than...

Quite possibly my time is better spent other than design simple layouts for a catalogue of them that already exists. My house needs to be cleaned also ... but at $10/hour I'll have someone else do it because it is cheaper than me doing it Not because I can't do it. Make sense fella? If you must...

I have 19 towns in one county who are banding together to get them so I though I'd like to offer them a catalogue of 50 or so to choose from rather than spend the time designing 50 of them...especially idf they are already available for purchase. And it has nothing to do with "thin Skin" it...

You guys are all high and mighty...lol... ya want a real laugh - check out my brochures on my website. Doubt any of you can make signs in stone. Truth be told I'm so busy doing a multitude of things...that "this guy" doesn't want to waste his $100/sq ft time designing simple template signs with...

Yep that's what I'm looking for.

Anyone know where I can purchase pre-made EPS/AI election templates? Thanks Kevin Signs from Above

Everybody starts somewhere !

Nice a C6 789..bet it goes too

The difference is the angle of the blade. The 60 degree blades are used to cut thicker materials of vinyl or sandblast mask. Of course the plotter needs enough down force to cut the thicker stuff. Many cheap plotters will not cut the thick sandblast mask. Hope that helps. Kevin

If it were me I would replace the piece rather than cobb it. But thats just me. Also 1/8" is too thin for 9'. It should be 1/4" or better yet 3/8".