• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Folksign

  1. Install Complete on our new 3000 Series Multicam Router

    Price for used CNC Hello, wondering what you might be asking for the 1000 series folksignstudio@hotmail.com thanks!

  2. Gerber Sabre 408 price research

    Sabre Jim I am intrested in talking to you about the sabre, where are you located? Please email me at folksignstudio@hotmail.com thanks Scott

  3. Edge Le Problem

    Just wish my Odyssey would countour cut the prints correctly........

  4. Edge Le Problem

    New foil squeegee new vinyl squeegee new struts, blew machine out with air......printing fine.

  5. Edge Le Problem

    Hi Fred, yes it was in place and it was shipped with a Gerber cartridge in the machine. I will try the connections tomorrow. Thank you

  6. Edge Le Problem

    Just picked up another Edge le. The guy I bought it from shipped it to me in the original box and it fired right up fine. Took about 2 minutes for the first warm up before printing. After running about 15 feet of vinyl using gerber foils it is missing pixels but not consistently. I cleaned the...

  7. Plotters and Edge off a USB HUB

    Thanks for the reply, still wondering if I can use a USB HUB. I am using a Edge LE and a Odyssey. Thanks
  8. F

    Hey Matthew, thanks for getting back with me on the Hub for the plotters and Edge. Im old school...

    Hey Matthew, thanks for getting back with me on the Hub for the plotters and Edge. Im old school with this stuff. How does a Ethernet cable adapt to the equipment? I have a Edge LE and a Odyssey that I want to run off the laptop. Thanks again. Scott

  9. Odyssey X Axis Gear replacement

    Got the part from Gerber and did it myself.....takes a bit of time but its better than paying the $ Glad to help if anyone needs it.....

  10. Plotters and Edge off a USB HUB

    Thanks for the quick reply!

  11. Plotters and Edge off a USB HUB

    Does anyone know if you can run Gerber plotters and a Edge off a usb hub. Thinking about using a laptop with Omega 4.0 and xp 32 bit. Will I need the Gerber USB adapters for this? Thanks,

  12. Odyssey X Axis Gear replacement

    Replacing the X Axis gear, parts ordered from Gerber. Looks like I need to loosen the set screws on the pinch wheels and slide the shaft to the right to remove the gear. I mic'd the measurements for the pinch wheels to set them back in the same place or within .001 or .002 Any advice from...
See more
Top