Recent content by MEISTER

Yea, I've done that. Calling US Cutter now.

Ha, Yea I can do one, maybe two. But then it craps out. I could run it on my Summa DC4, but it's not really made for just cutting vinyl. I may have to do that.

I'm running FlexiStarter 10.0.1 and have a US Cutter SC / LiYu SC Series plotter. I am using a USB 2.0 cable and not serial and have a USB 2.0 6ft extension to reach the plotter. Every time I cut, it starts cutting normal, but then about 2-3 decals into the plot, it veers off course and cuts a...

We figured out that applying wet works better with tape. Didn't try it without tape yet. I will try that right now. There is a specific technique to do it with tape, very light mist of RapidTac on both surface and backing. There are still a few bubbles and cant really do anything about that. I...

I am doing a vehicle graphic package on 5 dealership vehicles. I am using Oracle Oralite 5300 reflective vinyl. I am having real issues with bubbles in material. I am using RTape Conform Series 4076-RLA. I'm not a novice and have been doing this for a while. Some panels laid flat and look...

I really don't want to hear your suggestion unless it's positive. Either way, You can't buy the heads. Roland will only sell to authorized service repair shops and you have to pay to have them installed. Personally I don't want to pay $1000 to have someone install a print head when I can do it...

Ok, So my print head went bad a few weeks ago. I went though the normal procedures to test it and it for sure was bad. So I order a print head from the same company in China that manufactures them for Roland. $670. (ouch) This is the second time I bought from them and did not have any issues...

Anyone know a good place to buy Roland PC-60/600 Ribbons. Prefer Roland brand, but I will use into the ZeroNine and/or try refills. Post up. Thanks!

Ok, So I tried plotting to the paper with the black ribbon cut, so it imaged directly onto plain uncoated paper. That did not work. So I replaced all the CMYK cartridges with brand new ZeroNine cartridges. Still no change. I looked though all the settings too. I change the smooth Smooth Blends...

I am using Roland cartridges. They are the ones that came with the machine, so I assume they are old ribbons. Also the ribbon looked fairly haggard when I got them so I advanced the ribbon so it looked like a fresh ribbon. Also I did advance them the correct way. My example was actually not a...

Looks like a a font that someone created or was created in a program like Maya.

What is a head strike. BTW: The banding is not consistent. Some times it's every 1/2 inch, then skips a inch then has a few more 1/4" apart.

I just got a PC-60 about 3-4 months ago. I'm running FlexiPro 7.6v2. Everything is working fine. Got everything to print, cut and profiled. Now I'm facing banding issues. I adjusted the line pitch per the Roland manual. I tried the -.02 setting on the first test but that was a little too...

^Thanks I'll try that.

Ok, So I rebooted and turned everything back on... Now it's printing both my fills and strokes. I want to cut the strokes and print the fills. There is nothing in the Rip/Plot que that says anything about cutting. Any ideas?