Recent content by Melissam2505

I am selling a Roland 30" vinyl cutter. I am not sure if the USB port works, I have always connected it to the serial port on my computer because I couldn't get the USB to work, I think a pin might be bent. I am the original owner. It's had low use but works great and I have all manuals. It...

I have a 55" Cold Laminator for sale. In great shape and has had little use. Priced based on the fact you would have to come pick up and I live in East Idaho on the Jackson Hole, Wy border. I have a decent sized roll of laminate that would come with it. It has the foot pedal and the mouse to...

Thank you, I am working on it more today.

I am using the Roland Eco-Sol inks. I was wondering if the line was clogged.. but the fact I pulled air.. the test print corrected and then went out again.. I am not sure?

I have an SC 545. I was hoping someone would be nice enough to give me some advice. I recently went out of town and came back to some printing issues. I cleaned all the heads and they were fine.. printing was good. Then my magenta and light magenta started going out. So I cleaned heads and no...

This got buried in my last thread so I wanted to start a new one. I recently found out after converting my 540 to a 545 my lc and lm were switched and in the wrong order. So yesterday after getting help here, I switched both dampers. I then did some cleanings and test prints. I am attaching...

Here is a test print soon after switching the colors and what I am getting now after many other prints and cleanings.

I got my dampers switched. The first few test prints, no change. Did some cleanings. Eventually my lm gave out completely. And my lc slowly started magenta with about half the nozzles showing on the test print. I have done a zillion test prints and cleanings. My lm ( now in the right place) is...

Thanks. Do I need to do anything before powering off and unplugging?

Does anyone know if I need to be in service mode to swap the dampers/ink lines? I have been searching searching for detailed instructions on doing this for my printer and can't find anything. Its not in the manual and the service manual doesn't have damper replacement instructions either. Any...

Yes they are right in the back. I figured this out because I have had so many headaches with color so I bought an I1 Xtreme and on the color chart my cyan row starts out light magenta and my magenta row starts out light cyan. At least now I know why I have had SUCH a tough time. I will have to...

Yea thats what I have to do. I have to figure out how difficult it is and how hard it will be to flush them out. I hope its not complicated because flying a roland tech out is not cheap.

Thats the problem!!!!! My last two are lc lm. Now how the heck I fix this....

Im not sure what the order was as a 540 because I never used it that way. I just need to know the exact order of the 545. You are right about the left being Cyan now. Im curious what else is different.

Can someone tell me when they do a test print, what order the colors print from left to right? I have a SC 540 changed over to a 545 and I am having a strange problem.