Recent content by meris

Ok, I had to comeback on this problem! For some time (about two moths) I didn't use this printer (some personal reasons) and now I took it again to finally finish it and hopefully repair it! :supersmilie: I took all the heads out, cleaned up, fixed dampers and still have the same problem. Yellow...

Thank you I'll try that ..

Hi, can somebody help me with this (to me) strange problem. On Mutoh Rockhopper I, on nozzle check, don't have yellow, but I can see under black that yellow is printed. Can see yellow lines ???? :help Never saw anything like that even have the printer for almost five years ... How is this...

Thanks for thoughts .... Printed fine before with this ink, so doubt is ink problem. Clog, maybe, but I soak for long time that head, and no changes. ... Looks like the worst case scenario! Time to change head.:banghead: I guess there is no head repair possibility??? :covereyes:

Any body else has any ideas??? :thankyou:

Thanks for quick respond, but that's not the problem. I checked both and damper and o ring, but all are fine! :thankyou: Any other ideas??? :help

Hi I have Mutoh Rockhopper I for few years, and now have problem with primary black color. The problem is, actually two problems, the lines are split (compare cyan and magenta) and missing two top lines of black. I tried to soak the left head with no luck. Also increased rank number to I think...

Fixed Thank you randya, you were close .... He, when you are self teaching then sometime you get simple lessons but on hard way. The problem was on settings for media. It was set to cut media instead on roll (I never use cut media, actually I use cut but under roll ... ). I had no clue...

I'm loading now clear foil (or paper) and still is not working. I loaded printed media once when that started, after that I'm trying with clean media and having this problem. Thanks

Looks like no one have idea what can cause my problem ... ok! :noway: Does any body know where I can find electronic schema of the main board for Mutor Rockhopper I (or Falcon Outdoor)??? That will help me to figure out what controls the keyboard panel and display which I have problem with...

Hi I have problem with my Mutoh RockHopper I. Suddenly the buttons for moving roll back and forth do not work. Check nozzle prints the boxes then feed roll to the end of roll end shows "End of roll" message. Before that I feed roll that has been printed and had error "Undefined media", but...

Hi, when I do Test nozzle print I have deflection on black and cyan box. They are not missing nozzle but some small lines are in same line as previous. The attachment shows what I'm talking about. Any body know what to do? I cleaned the head and soaked in the cleaning fluid. Don't know what else...

Oooo, :doh: I guess, yes. I got it two months ago, and I'm pretty sure previous owner used OEM. Thanks for the clarification.

No, I'm not using original Mutoh ink, if that's what OEM means.

Hi I'm new in the sign printing business, and also on the forum. I hope to find help here and maybe to help somebody. I have Rockhopper 62" and some strange problem with it. Have a project to print out several bigger signs (60" x 70"). It starts well with printing a sign, but after maybe 40%...