Recent content by nopalito24

If you still have this issue, just turn on ISM mode(look up what it does in users manual) its meant for these types of issues on glossy medias/specialty, MENU, Arms, Scanning Speed, ISM.

If you have confirmed that on non laminated prints the sensor finds the marks, then of course you now know that it is the laminate that the plotter is having a problem with. So, the fC8600 has a feature called ISM(intelligent scanning mode) turn it ON: MeNU, Arms, Sensing Speed, ISM, ENTER. Try...

still need this part? which part? can you send a pic or description?

did u already find your tubing?

Js501 Pic, sorry.

Js501 Hey, I actually have 3 new bulk system cartridges for JS501, are these the ones you need?(see pic)

first make sure where the problem is coming from. Send a 24 in by 24 in square to cut(not contour cut just normal cutting) then measure it. If not to size then you may need to contact Graphtec and ask for the Distance Accuracy adj. which is in the plotters service mode. If this is only happening...

Hello, No they are not, you can go ahead and remove them. The most important thing on this kind of machine is ink flow, make sure your dampers are not punctured, really hard to see if they are but you will notice air bubbles in your ink lines if they are.

most likely you have a damaged(separted) Y pulley. If you remove the right side cover you'll see a pulley that is made up of 2 parts, a cylindrical pc. and a round pc. over the cylindrical pc you'll see the big carriage belt, on on the round pc. you'll see the Y drive belt going to the motor...

I have some parts for this machine, let me know which one of the push roller assy. do you need. left, right? send a pic if possible. either here or private message.

this has nothing to do w/ the way the plotter is configured because this issue happens when you click Cut/Plot and CM2 times out while waiting for CM2 to open. If reinstalling CM2 w/ the security software disabled did not work, then you may need to remove it again, download the latest version...

for this I strongly suggest you contact Wasatch, because you are getting a spooler error. On the Graphtec you really don't have to set anything up except for your Command option to HPGL.

hello, I also used to have one of these and have some left over parts including a new pen block(cutting head) if you are interested. will like to sell the hole thing as an assembly. let me know via private massage.

good cutter which also comes w/ a reg. mark sensor for countour cutting. if you go here: www.graphtecamerica.com/support you can pick up a copy of CM2- just click on any current model and grab it from there. This is a plug in for Adobe Ill. and Corel Draw so that you can cut directly from either...

are we talking print and cut? if so go to section 4.7 of your users manual, adjusting the registration mark sensor